It is a ready-to-use pure photopolymer emulsion with medium viscosity, high solids and exposure times up to 3 times lower than other types of emulsions. It is an excellent emulsion of very easy copying and recovery, which counts among its advantages the possibility of emulsifying frames and storing them in a dark room until the time of its use, besides not leaving diazo stains in the fabrics.

Applicaciones

It is used in industrial and advertising printing. Resists solvent and UV inks.

Mode of Use

On a clean and degreased mesh, apply 1 or 2 hands on the side of the print followed by 1 or 2 hands on the side of the handle. For jobs where greater definition is required, the number of hands on both sides must be increased. The already emulsified frame is allowed to dry with the print side down in an environment of hot, dry and dust-free air, not to exceed 40 ° C. All these operations must be carried out under yellow light or low voltage tungsten lamp, avoiding exposure to sunlight or to halogen, fluorescent or quartz type lamps. Once copied wash the frame with cold water and let it dry.

Exposure

The exposure time depends on the distance, film thickness, fabric color, lamp usage time, etc. With the use of white fabrics the time is reduced to half, with respect to colored fabrics. Indicatively the value taken in our sunshine with a lamp (of 5000 w) metal halogen with integrator to 1 meter of distance, with four hands of emulsion applied (2 external and 2 internal), on a cloth of 120 threads / cm of color and Using an "exposure calculator" the result is 10-15 light times (approximately 25 "- 38").

Recovery

After cleaning the ink and with the dry screen, apply EMULQUIT GEL on both sides. Let it act for 5 minutes, then rinse with water under pressure. The use of a washer is recommended. It is not advisable that the permanence of the recuperative product acted more than the indicated time, to avoid that when drying becomes difficult to recover.

Storage

Containers should be tightly closed. Store in a cool, dark place. Avoid temperatures above 35 ° C (change the symbol for degrees). The duration of the emulsion is approximately 1 year if well preserved; Exceeded this time we recommend checking the copying capacity of the same.

Tips and possible solutions

If the image does not develop or does it with some difficulty:
· Very long exposure time.
· Accidental exposure to white light before recording.
· Very high drying temperature (do not exceed 40 ° C).

If the emulsion leaves or falls from the fabric:
· Increase exposure time.
· Check that the emulsion is perfectly dry.
· Sensitized emulsion for a long time.
· Poorly sensitized emulsion.
· Excessive ambient humidity.

Important note

I. The inks formulated by Pintesint SAICyF must be used exclusively with the solvents and the complementary products that it manufactures for that purpose. Due to the diversity of products in the market, the company is not responsible for the use of the same from another source.
II. The suggestions and data of this literature were elaborated in good faith, to guide the user. We recall the importance of checking the adaptability of inks and complementary products by testing before starting production. Due to the fact that the conditions of use of the products are not under our control, the present does not constitute a guarantee on the work to be done.