It is a fast curing ink, high gloss and an ideal viscosity for its correct definition. It has been specially developed for paper printing. With a line of colours of good resistance to the intemperie in which the polychromatic tones are included.

Auxiliares

Polychromatic Concentrates: It is a concentrate of pigments to raise the tones of the inks. They modify the speed of curing, so it is recommended not to add more than 5%.

BUV024 Yellow
BUV055 Magenta
BUV074 Cyan
BUV090 Black

Curing accelerator 11042: It is recommended to add 1 to 5% if necessary.

Reducer of non-active viscosity 11047: An excess can modify the characteristics of the ink, not add more than 5%.

General Recommendations

Do not mix this line of inks with any product not recommended in the previous point (AUXILIARS).

Curing

The cure rate depends on the following factors, lamp status, film thickness and color. Check these points before adding curing accelerator.

Pre-Print Test

Check the characteristics of the substrates before use, checking the adhesion of the ink.

Curing Deficiencies

If you get poor curing with any of the colours, shown through wet film or loss of brightness, it is usually due to an excessive ink tank. To correct this, factors such as mesh, manigueta rubber, color density, band speed or amount of UV energy must be modified.

Storage

Almacenar en lugar protegido de la luz y en recipientes de polietileno negro, debido a que la exposición a la luz produce la polimerización de la tinta. Los envases deben cerrarse muy bien, e inmediatamente después de usar las tintas. Para maximizar la vida de almacenamiento, la temperatura de almacenaje debe ser de 10 ° C (corregir simbolo de grados) a 25 ° C (50 ° F - 77 ° F). La estabilidad de la tinta es de un año cumpliendo los requisitos mencionados.

Safety

Contact with skin causes irritation, in this case wash with plenty of soap and water. Wear gloves and eye protection. Change contaminated clothing and consult a doctor.

Important note

I. The inks formulated by Pintesint SAICyF must be used exclusively with the solvents and the complementary products that it manufactures for that purpose. Due to the diversity of products in the market, the company is not responsible for the use of the same from another source.
II. The suggestions and data of this literature were elaborated in good faith, to guide the user. We recall the importance of checking the adaptability of inks and complementary products by testing before starting production. Due to the fact that the conditions of use of the products are not under our control, the present does not constitute a guarantee on the work to be done.